Register
Filter

Most viewed questions in Digital Circuits

0 votes
0 answers
43
GATE ECE 2013 | Question: 45
There are four chips each of $1024\:\text{bytes}$ connected to a $16\:\text{bit}$ address bus as shown in the figure below. $RAMs\: 1, 2, 3$ and $4$ ... $0500H-08FFH, 1500H-18FFH, 3500H-38FFH, 5500H-58FFH$ $0800H-0BFFH, 1800H-1BFFH, 2800H-2BFFH, 3800H-3BFFH$
There are four chips each of $1024\:\text{bytes}$ connected to a $16\:\text{bit}$ address bus as shown in the figure below. $RAMs\: 1, 2, 3$ and $4$ respectively are mapp...
0 votes
0 answers
46
GATE ECE 2018 | Question: 8
The logic function $f(X, Y)$ realized by the given circuit is NOR AND NAND XOR
The logic function $f(X, Y)$ realized by the given circuit is NORANDNANDXOR
0 votes
0 answers
47
GATE ECE 2017 Set 1 | Question: 45
The following FIVE instructions were executed on an $8085$ microprocessor. MVI A, $33$H MVI B, $78$H ADD B CMA ANI $32$H The Accumulator value immediately after the execution of the fifth instruction is $00H$ $10H$ $11H$ $32H$
The following FIVE instructions were executed on an $8085$ microprocessor.MVI A, $33$HMVI B, $78$HADD BCMAANI $32$HThe Accumulator value immediately after the execution o...
0 votes
0 answers
49
GATE ECE 2021 | Question: 12
​​​​​​Addressing of a $32K\:\times\:16$ memory is realized using a single decoder. The minimum number of $\text{AND}$ gates required for the decoder is $2^{8}$ $2^{32}$ $2^{15}$ $2^{19}$
​​​​​​Addressing of a $32K\:\times\:16$ memory is realized using a single decoder. The minimum number of $\text{AND}$ gates required for the decoder is$2^{8}$...
0 votes
0 answers
51
GATE ECE 2020 | Question: 20
A $10$-bit D/A converter is calibrated over the full range from $0$ to $10$ V. If the input to the D/A converter is $13 \:A$ (in hex), the output ( rounded off to three decimal places) is __________ $V$.
A $10$-bit D/A converter is calibrated over the full range from $0$ to $10$ V. If the input to the D/A converter is $13 \:A$ (in hex), the output ( rounded off to three d...
0 votes
0 answers
53
GATE ECE 2019 | Question: 15
In the circuit shown, $A$ and $B$ are the inputs and $F$ is the output. What is the functionality of the circuit? Latch XNOR SRAM Cell XOR
In the circuit shown, $A$ and $B$ are the inputs and $F$ is the output. What is the functionality of the circuit?LatchXNORSRAM CellXOR
0 votes
0 answers
54
GATE ECE 2016 Set 3 | Question: 17
The logic functionality realized by the circuit shown below is $OR$ $XOR$ $NAND$ $AND$
The logic functionality realized by the circuit shown below is $OR$$XOR$$NAND$$AND$
0 votes
0 answers
55
GATE ECE 2017 Set 2 | Question: 15
For the circuit shown in the figure, P and Q are the inputs and Y is the output. The logic implemented by the circuit is XNOR XOR NOR OR
For the circuit shown in the figure, P and Q are the inputs and Y is the output.The logic implemented by the circuit isXNOR XORNOROR
0 votes
0 answers
56
GATE ECE 2019 | Question: 14
In the circuit shown, what are the values of $F$ for $EN=0$ and $EN=1,$ respectively? $\text{0 and D}$ $\text{Hi-Z and D}$ $\text{0 and 1}$ $\text{Hi-Z and}$ $ \overline{D}$
In the circuit shown, what are the values of $F$ for $EN=0$ and $EN=1,$ respectively?$\text{0 and D}$$\text{Hi-Z and D}$$\text{0 and 1}$$\text{Hi-Z and}$ $ \overline{D}$
0 votes
0 answers
63
GATE ECE 2014 Set 3 | Question: 15
The circuit shown in the figure is a Toggle Flip Flop JK Flip Flop SR Latch Master-Slave D Flip Flop
The circuit shown in the figure is a Toggle Flip FlopJK Flip FlopSR LatchMaster-Slave D Flip Flop
1 votes
0 answers
65
GATE ECE 2015 Set 2 | Question: 14
In the figure shown, the output ܻ$Y = AB + \overline{C}\:\:\overline{D}$ is required to be ܻ The gates $G1$ and $G2$ must be, respectively, NOR, OR OR, NAND NAND, OR AND,NAND
In the figure shown, the output ܻ$Y = AB + \overline{C}\:\:\overline{D}$ is required to be ܻ The gates $G1$ and $G2$ must be, respectively,NOR, OROR, NANDNAND, ORAND,NA...
0 votes
0 answers
69
GATE ECE 2014 Set 2 | Question: 41
The outputs of the two flip-flops $Q1$, $Q2$ in the figure shown are initialized to $0,0$. The sequence generated at $Q1$ upon application of clock signal is $01110 \dots$ $01010\dots$ $00110\dots$ $01100\dots$
The outputs of the two flip-flops $Q1$, $Q2$ in the figure shown are initialized to $0,0$. The sequence generated at $Q1$ upon application of clock signal is $01110 \dots...
0 votes
0 answers
70
GATE ECE 2012 | Question: 6
Consider the given circuit. In the circuit, the race around does not occur occurs when $\text{CLK}=0$ occurs when $\text{CLK}=1$ and $A=B=1$ occurs when $\text{CLK}=1$ and $A=B=0$
Consider the given circuit.In the circuit, the race arounddoes not occuroccurs when $\text{CLK}=0$occurs when $\text{CLK}=1$ and $A=B=1$occurs when $\text{CLK}=1$ and $A=...
1 votes
0 answers
72
GATE ECE 2015 Set 2 | Question: 36
A function of Boolean variables $X, Y$ and $Z$ is expressed in terms of the min-terms as $F(X, Y, Z) = \Sigma (1, 2, 5, 6, 7)$ Which one of the product of sums given below is equal to the function $F(X, Y, Z)?$ ...
A function of Boolean variables $X, Y$ and $Z$ is expressed in terms of the min-terms as $$F(X, Y, Z) = \Sigma (1, 2, 5, 6, 7)$$Which one of the product of sums given bel...
1 votes
0 answers
73
GATE ECE 2014 Set 3 | Question: 42
If $X$ and $Y$ are inputs and the Difference $(D=X-Y)$ and the Borrow $(B)$ are the outputs, which one of the following diagrams implements a half-subtractor?
If $X$ and $Y$ are inputs and the Difference $(D=X-Y)$ and the Borrow $(B)$ are the outputs, which one of the following diagrams implements a half-subtractor?
1 votes
0 answers
75
GATE ECE 2014 Set 4 | Question: 15
In the circuit shown in the figure, if $C=0$, the expression for $Y$ is $Y=A \overline{B} + \overline{A}B$ $Y=A+B$ $Y=\overline{A} + \overline{B}$ $Y=A \: B$
In the circuit shown in the figure, if $C=0$, the expression for $Y$ is$Y=A \overline{B} + \overline{A}B$$Y=A+B$$Y=\overline{A} + \overline{B}$$Y=A \: B$
0 votes
0 answers
76
GATE ECE 2014 Set 4 | Question: 16
The output $(Y)$ of the circuit shown in the figure is $\overline{A} + \overline{B} +C$ $A + \overline{B} \cdot \overline{C} + A \cdot \overline{C}$ $\overline{A} +B+\overline{C}$ $A \cdot B \cdot \overline{C}$
The output $(Y)$ of the circuit shown in the figure is$\overline{A} + \overline{B} +C$$A + \overline{B} \cdot \overline{C} + A \cdot \overline{C}$$\overline{A} +B+\overli...
0 votes
0 answers
77
GATE ECE 2020 | Question: 19
In an $8085$ microprocessor, the number of address lines required to access a $16$ K byte memory bank is ____________ .
In an $8085$ microprocessor, the number of address lines required to access a $16$ K byte memory bank is ____________ .
0 votes
0 answers
79
GATE ECE 2014 Set 3 | Question: 40
If WL is the Word Line and BL the Bit Line, an SRAM cell is shown in
If WL is the Word Line and BL the Bit Line, an SRAM cell is shown in
0 votes
0 answers
80
GATE ECE 2017 Set 2 | Question: 17
In a DRAM, periodic refreshing is not required information is stored in a capacitor information is stored in a latch both read and write operations can be performed simultaneously
In a DRAM, periodic refreshing is not required information is stored in a capacitor information is stored in a latchboth read and write operations can be performed simult...
Page: