Recent questions tagged circuit-analysis

1 1 vote
1 1 answer
826
826 views
A series $\text{RLC}$ circuit has a quality factor $\text{Q}$ of $1000$ at a center frequency of $10^{6} \; \mathrm{rad} / \mathrm{s}$. The possible values of $\text{R,...
0 0 votes
0 0 answers
1.7k
1.7k views
In the circuit shown below, $\text{V}_1$ and $\text{V}_2$ are bias voltages. Based on input and output impedances, the circuit behaves as avoltage controlled voltage sour...
0 0 votes
0 0 answers
1.1k
1.1k views
The synchronous sequential circuit shown below works at a clock frequency $1 \; \mathrm{GHz}$. The throughput, in $\text{Mbits/s,}$ and the latency, in $\text{ns,}$ respe...
3 3 votes
1 1 answer
1.3k
1.3k views
In the circuit shown below, the current $i$ flowing through $200 \; \Omega$ resistor is___________ $\mathrm{mA}$ (rounded off to two decimal places).
1 1 vote
0 0 answers
1.6k
1.6k views
For the two port network shown below, the $[\mathrm{Y}] – $parameters is given as$$[Y]=\frac{1}{100}\left[\begin{array}{cc}2 & -1 \\ -1 & 4 / 3\end{array}\right] S$$The v...
1 1 vote
0 0 answers
588
588 views
In the circuit shown below, switch $\mathrm{S}$ was closed for a long time. If the switch isopened at $t=0$, the maximum magnitude of the voltage $\mathrm{V}_{\mathrm{R}}...
0 0 votes
0 0 answers
652
652 views
The $\frac{V_{\text {OUT }}}{V_{\text {IN }}}$ of the circuit shown below is$-\frac{\mathrm{R}_4}{\mathrm{R}_3}$$\frac{\mathrm{R}_4}{\mathrm{R}_3}$$1+\frac{\text{R}_4}{\t...
2 2 votes
0 0 answers
996
996 views
In the circuit shown below, $D_1$ and $D_2$ are silicon diodes with cut-in voltage of $0.7 \mathrm{~V}$. $\mathrm{V}_{\mathrm{IN}}$ and $\mathrm{V}_{\mathrm{OUT}}$ are in...
1 1 vote
0 0 answers
473
473 views
The switch $\mathrm{S}_{1}$ was closed and $\mathrm{S}_{2}$ was open for a long time. At $t=0$, switch $\mathrm{S}_{1}$ is opened and $\mathrm{S}_{2}$ is closed, simultan...
1 1 vote
0 0 answers
390
390 views
The $\text{h}$-parameters of a two port network are shown below. The condition for the maximum small signal voltage gain $\frac{\mathrm{V}_{\text {out }}}{\mathrm{V}_{\ma...
0 0 votes
0 0 answers
406
406 views
The following circuit(s) representing a lumped element equivalent of an infinitesimal section of a transmission line is/are
1 1 vote
1 1 answer
1.9k
1.9k views
In a given sequential circuit, initial states are $Q_1=1$ and $Q_2=0$. For a clock frequency of $1 \; \mathrm{MHz}$, the frequency of signal $\mathrm{Q}_2$ in $\mathrm{kH...
1 1 vote
0 0 answers
692
692 views
In the circuit below, the voltage $V_L$ is _________ $\mathrm{V}$ (rounded off to two decimal places).
2 2 votes
0 0 answers
458
458 views
What is the following passive circuit?Low-pass filterHigh-pass filterBand-pass filterBand-stop filterAll-pass filter
1 1 vote
0 0 answers
331
331 views
The input to a series $\text{RLC}$ circuit is a sinusoidal voltage source and the output is the current in the circuit. Which of the following is true about the magnitude...
1 1 vote
0 0 answers
379
379 views
In household electrical wiring which configuration is used to connect different electrical equipments.Series.ParallelCombination of series and parallel.Any of the above.N...
1 1 vote
0 0 answers
336
336 views
A voltage source with internal resistance $\text{R}$ is connected to an inductor $\text{L}$ and a capacitor $\text{C}$ connected in parallel. The output is the common vol...
1 1 vote
0 0 answers
333
333 views
Suppose a $1 \mu \mathrm{H}$ inductor and a $1 \Omega$ resistor are connected in series to a $1 \mathrm{ V}$ battery. What happens to the current in the circuit?The curre...
1 1 vote
0 0 answers
371
371 views
What is the maximum average power that can be dissipated by a load connected to the output terminals of the following circuit with an alternating current source?$23 \math...
1 1 vote
0 0 answers
288
288 views
Consider the opamp circuit in the figure. Approximately what is $V_{0}$?$-\left(\frac{V_{1}}{2}+V_{2}\right)$$-\left(\frac{V_{1}}{4}+\frac{V_{2}}{2}\right)$$-\left(V_{1}+...
0 0 votes
0 0 answers
420
420 views
Statement of Linked Answer Questions $84a$ and $84b$Voltage standing wave pattern in a lossless transmission line with characteristic impedance $50 \mathrm{W}$ and a resi...
1 1 vote
0 0 answers
451
451 views
The current $i_4$ in the circuit of the figure is equal to$12 \mathrm{~A}$$-12 \mathrm{~A}$$4 \mathrm{~A}$None of these
0 0 votes
0 0 answers
438
438 views
The voltage $\mathrm{V}$ in the figure is equal to$3 \mathrm{~V}$$-3 \mathrm{~V}$$5 \mathrm{~V}$None of these
0 0 votes
0 0 answers
409
409 views
The voltage $\mathrm{V}$ in the figure is always equal to$9 \mathrm{~V}$$5 \mathrm{~V}$$1 \mathrm{~V}$None of the above
1 1 vote
0 0 answers
562
562 views
The voltage $V$ in the figure is$10 \mathrm{~V}$$15 \mathrm{~V}$$5 \mathrm{~V}$None of the above
1 1 vote
1 1 answer
875
875 views
In the circuit of the figure is the energy absorbed by the $4 \; \Omega$ resistor in the time interval $(0, \infty)$ is$36$ Joules$16$ Joules$256$ JoulesNone of the above
1 1 vote
0 0 answers
544
544 views
In the circuit of the figure is the equivalent impedance seen across terminals $\text{a, b}$ is$\left(\frac{16}{3}\right) \Omega$$\left(\frac{8}{3}\right) \Omega$$\left(\...
0 0 votes
0 0 answers
321
321 views
In the circuit of in the figure is the current $i_{D}$ through the ideal diode (zero cut in voltage and forward resistance) equals$0 \mathrm{~A}$$4 \mathrm{~A}$$1 \mathrm...
0 0 votes
0 0 answers
527
527 views
A communication channel has first-order low pass transfer function. The channel is used to transmit pulses at a symbol rate greater than the half-power frequency of the l...
0 0 votes
0 0 answers
421
421 views
The transistor in the circuit shown in the figure is so biased ($dc$ biasing network is not shown) that the $dc$ collecter current $I_{c}=1 \mathrm{~mA}$. Supply is $V_{c...