Recent questions tagged circuit-analysis

The ideal $\text{OP-AMP}$ circuit shown in the Figure produces output voltage $V_{o}=x$ when the Switch, $\text{S}$, is open.Which of the options represents the output vo...

Consider the circuit shown in the Figure with $V_{i}=3 \mathrm{~V}$ and $V_{C C}=12 \mathrm{~V}$.Assume $V_{B E}=0.7 \mathrm{~V}$ and $\beta_{d c}=99$ for the BJT.Which o...

The relation between the input current ( $I$ ) and the output voltage ( $V$ ) of a circuit is governed by the equation: $C \dfrac{d V}{d t}=I(t)-m(t)$. The circuit is exc...

The output voltage $V_{o}$ (in Volt) for the network given in the Figure is $\_\_\_\_$ .(rounded off to two decimal places) 

Consider the circuit shown in the Figure, where the input $v_{i}(t)$ is in Volt.The average power (in $\text{mW}$ ) dissipated in the load resistance of $1 ~\mathrm{k} \O...

A circuit using an ideal $\text{OP-AMP}$ is shown in the Figure.Which of the following options gives the correct value of the current $I_{X}$?$2.0$ mA$1.5$ mA$3.0$ mA$0$ ...

Consider an ideal OP-AMP circuit as shown in the Figure.The resistances $R_{1}=R_{2}=R_{3}=R_{4}=50 \mathrm{~k} \Omega$.The magnitude of the closed loop gain is $\_\_\_\_...

Consider a part of an electrical network as shown below. Some node voltages, and the current flowing through the $3 \Omega$ resistor are as indicated.The voltage (in Volt...

A simplified small-signal equivalent circuit of a BJT-based amplifier is given below.The small-signal voltage gain $V_{o} / V_{S}$ (in $\mathrm{V} / \mathrm{V})$ is $\_\_...

All the components in the bandpass filter given below are ideal. The lower $-3$ dB frequency of the filter is $1$ MHz.The upper $-3$ dB frequency (in MHz , rounded off to...

In the circuit below, $M_{1}$ is an ideal AC voltmeter and $M_{2}$ is an ideal AC ammeter. The source voltage (in Volts) is $v_{s}(t)=100 \cos (200 t)$.What should be the...

A positive-edge-triggered sequential circuit is shown below. There are no timing violations in the circuit. Input $P 0$ is set to logic '$0$ ' and $P 1$ is set to logic '...

Two resistors are connected in a circuit loop of area $5 \mathrm{~m}^{2}$, as shown in the figure below. The circuit loop is placed on the $x-y$ plane.When a time-varying...